![]() Base line: An imaginary line running east and west a baseline intersects with a meridian.Acre: 43,560 square feet or 4840 square yards 640 acres = 1 square mile.The FamilySearch Wiki in general is an excellent reference tool, and they have good information regarding United States land records. These definitions were taken from the FamilySearch Wiki, specifically the United States Land Terms and Definitions page. Listed below are some definitions of common words you may see used in a deed described through Rectangular Survey. Washington Township) while survey townships were numbered (e.g. Don’t forget, though, that the term township was also used to indicate a small geographic area within a county. If you see phrases including halves, quarters, sections, townships, and ranges, it is safe to say that you are dealing with a deed described in Rectangular Survey. Knowing these terms can help you understand whether or not your deed was described in Rectangular Survey, as well as help you get a sense of how much property was bought before you even draw out the description. The following are Federal Land States, and thus you should expect to graph land from these states:Īs with Metes and Bounds land platting, it is helpful to know some of the terms or phrases that you should expect to see in a Rectangular Survey land deed. As mentioned in Part I, the State Land States generally used Metes and Bounds, which requires land platting. Federal Land StatesĪs a reminder – Rectangular Survey was used primarily in the Federal Land States. Many schools were built in Section 16 of their township, or the proceeds from sales in that section were designated specifically to fund public education. On an interesting note- Section 16 of each township was set apart specifically for public education. This land was then sold in portions of the sections, often divided in halves, quarters, etc. These townships would be further divided into 1-square-mile sections, for a total of 36 sections per township. It involved dividing up the land into square townships that measured 6 miles along each side. This was called the Public Land Survey System. On May 20, 1785, the United States passed the Land Ordinance of 1785, which set precedent for how the government’s acquired land would be divided up and sold. Graphing refers to land described using the Rectangular Survey system. Land Graphing, just as land platting, involves drawing out the land description found in a land record, usually a land grant (the first sale of the land from the government to an individual) or a land deed (subsequent sales of the land between individuals). Land platting, however, is only half of the equation! Here in Part II we’ll talk about Land graphing, which is similar to platting but used in different situations. In Part I of this two-part series, we discussed the importance of Land Platting – drawing out property boundaries as given in land records. ![]() These records do more than simply record where an ancestor lived or what property they owned they can be a wealth of information about relationships, economic status, and much more! Land records are an incredibly important resource when doing genealogy research in the United States.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |